LATEST UPDATES

Tuesday, 11 April 2017

Partial Balancing of Locomotives

          The locomotives, usually, have two cylinders with cranks located at right angles (90°) to each other in order to have uniformly turning moment diagram and also the engine can be started easily after stopping in any position. Balance masses are placed on the wheels in both types. 
        In coupled locomotive, wheels are coupled by connecting their crank pins with coupling rods. As the coupling rod revolves with the crank pin, its proportionate mass can be considered as a revolving mass which can be completely balanced. 

Locomotive engines depending upon the location of cylinders they, are classified in two types they are:
           1. Inside cylinder engine and 2. Outside cylinder engine. 

          In the Inside cylinder locomotives, the two cylinders are placed in between the planes of two driving wheels as shown in Fig., Whereas in the Outside cylinder locomotives, the two cylinders are placed outside the driving wheels one on each side of the driving wheel, as shown in Fig., 
          They are further classified as Coupled and Uncoupled. If two or more pairs of wheels are coupled together to increase the adhesive force between the wheels and the track, it is called as coupled locomotive. otherwise, it is called as uncoupled locomotive.
          A single or uncoupled locomotive is one, in which the effort is transmitted to one pair of the wheels only; Whereas in coupled locomotives, the driving wheels are connected to the leading and trailing wheel by an outside connecting rod.
          Thus, whereas in uncoupled locomotive, there are four planes for consideration, two of the cylinders and two of the driving wheels, In coupled locomotives there are six planes, two of cylinders, two of coupling rods and two of wheels. The planes which contain the coupling rod masses lie outside the planes that contain the balance (counter) masses. Also, in case of coupled locomotives, the mass required to balance the reciprocating parts is distributed among all the wheels which are coupled. Thus, results in a reduced Hammer Blow.

No comments:

Post a Comment

@2017 All Rights Reserved. Designed by WWW.SMARTWAY2STUDY.COM !!!! Sitemap !!!! Blogger Templates